PIONEER 1X26X23 Red Dot Sight

FAQ

1. Why the sight is not powering up?

Please check if the battery is dead and replace a new battery when needed. It is always good to carry a spare battery with you.

Please make sure the battery is installed with + facing out.

Please make sure the contact points are clean, and battery cover is firmly screwed down.

2. Why motion activate is not working?

If the sight is powered off manually, the motion activate function will be turned off simultaneously. The sight must be left on and enter standby mode for motion activate function to work.

3. Why seeing blurry dot?

Make sure that you are looking through the sight at the target, not the dot.

Reduce the reticle brightness.

If you are prescribed with corrective lenses, please wear them.

4. Why bullets are not grouping?

Please make sure all the mount screws are firmly tighten, and the sight is mounted firmly .

5. Why seeing glare?

Some amount of glare is going to present in reflex/reflective sights due to the coatings on the objective lens.

PIONEER 1X26X23 Red Dot Sight

Deixar um comentário

Todos os comentários são revisados antes de serem publicados.

Este site é protegido por hCaptcha e a Política de privacidade e os Termos de serviço do hCaptcha se aplicam.